Tap to chain points from the base out to the rim · drag a point to move it · drag a segment's handle to curve it · both sides mirror as you design. The curve is smoothed, so corners round themselves away. This is the master pot you'll copy and merge.
Tap to sketch a side profile
base first, rim last · 1 grid square = ¼ in
base first, rim last · 1 grid square = ¼ in
Drag a pot to slide it across the table · Shift-drag to raise or lower it · drag empty space to orbit the view.
This is the whole merged pot. Where a pot's wall faces another pot, that wall is a face you can cut off to open the pots into each other · hover to reveal a face, click to cut it away · cut pieces are listed in the Cuts panel — click one there to put it back · drag empty space to orbit the view.